Vehicle application:

Citroen
Citroen Jumper (250) 05/2014 - 10/2022*
Citroen Jumper (250) 10/2022 - 2024*
Citroen e-Jumper (259 10/2021 - 2024
Citroen Relay (250) 2006- 2024*

Fiat
Fiat 500 (ZAF 312) 07/2016 - 2023
Fiat 500L (ZAF 199) 10/2012 - 07/2017
Fiat 500L (ZAF 199) 07/2017 - 03/2022
Fiat Doblo (ZAF 263) 01/2015 - 06/2022
Fiat Ducato (ZFA 250) 05/2014 - 11/2021*

Opel
Opel Movano Cargo C (Y) 10/2021 - 01/2024*
Opel Movano Cargo C (Y) 01/2024 - 2024*
Opel Movano Electric Cargo C (Y) 10/2021 - 01/2024*
Opel Movano Electric Cargo C (Y)  01/2024 - 2024*

Peugeot
Peugeot Boxer (Y) 09/2014 - 12/2019*
Peugeot Boxer (Y) 08/2018 - 2024*
Peugeot e-Boxer (Y) 10/2021 - 2024* 

Following signals are provided:

Reimported vehicles or vehicles with different software may be incompatible in functions.

red: +12V ignition clamp 15
orange: +12V illumination clamp 58
purple/white: +12V reverse gear signal
pink: speed pulse signal
green: GND park brake signal

load capacity outputs: 250 mA max.

current requirement more than 250 mA:
1 relay coil resistance 75 Ohm min.
2 relays coil resistance 150 Ohm min.

SWC

*vehicles with Daiichi OEM HU wiring harness black cables > Dismantle adapter wiring harness radio slot driver's side
*vehicles with direct wired OEM Daiichi HU coloured cables not compatible > contact the support/look item: 42xfa016
**vehicle setting retention:
Infodapter Citroen/Fiat/Opel/Peugeot 52Pin Fiat VP1/VP2 > item: 43uft01

Note:

CAN Bus

connector: 52 Pin Fiat
connector: OEM SWC > 3,5mm Jack / loose wire
connector: OEM rear view camera > RCA(m) yellow rear viev camera input

vehicles with Continental 250VP1 / 250VP2 OEM HU
vehicles with UConnect OEM HU
vehicles with Daiichi OEM HU*

dip switch settings for the retrofit device manufacturer (look into the manual)

vehicles with error display trip meter after installation > dip switch position:
adjust dip switch position voltage-free

dip switch 1 on / dip switch 2 off / cut or loop white wire
dip switch 1 off / dip switch 2 on / cut or loop white wire

dip switch 6 on > 250VP1 OEM HU
dip switch 5 on > 250VP2 OEM HU
cut white loop > Blue&Me OEM function

dip switch 1 off / dip switch 2 off / cut white loop > Daiichi OEM Gerät

after changeover CAN Bus must shut down 

vehicles with persistent error display and other software package not compatible

vehicle settings not supported**
high beam assistance not supported
driver assistance systems not supported
date/time adjustment not supported**